3D printed RC and FPV drone parts in Dhaka
Updated
We print accessory parts for RC cars and FPV drones in PLA: GoPro and camera mounts, antenna holders, bumpers, electronics covers and field accessories. We are also plain about which parts should not be PLA at all.
Good jobs for PLA
- GoPro and action camera mounts, and FPV camera tilt wedges
- Antenna holders and receiver cases
- Covers over the flight controller, receiver or wiring
- Bumpers and front guards for crawlers and slower hobby cars
- Light bar mounts and scale accessories for crawler bodies
- Transmitter stands, battery organisers and field boxes
Parts we would steer you away from
PLA softens around 55–60°C, and brushless motors, ESCs and LiPo packs can reach that after a hard run, so a PLA motor mount can sag or let go in the air. It is also brittle under sharp impact: a freestyle quad's frame arm or a basher's suspension arm will snap where carbon fibre, nylon or TPU would survive. Buy those parts in the proper material and use PLA for what sits around them. And do not leave PLA parts in a car parked in the Dhaka sun; the inside gets hot enough to warp them.
What to send
Most RC and FPV accessories are already on MakerWorld, Printables and Thingiverse, sorted by frame or model, so a link is the easiest order. Many are published for TPU; tell us, and we will check whether the design makes sense in PLA before quoting. Your own designs can come as STL, 3MF or STEP on Google Drive. With no model, name your frame or chassis and describe the part with measurements, and we will try to find or adapt one close to it.
Screws, weight and fit
Quads mostly use M2 and M3 hardware and RC cars M3 and M4; model holes a touch oversize or drill them out, and use nuts, since we do not fit heat-set inserts. Leave about 0.2–0.3 mm of clearance where a part slides over a tube or arm. On a drone every gram shows up in flight time, so say if weight matters: thinner walls and lighter infill save grams at some cost to stiffness.
Colour and finish
Black is the usual choice on drones because it hides scuffs and does not throw glare into the camera. White is easier to find in long grass after a crash. Parts that will get knocked about are best left "as printed"; "sanded and painted" suits a scale crawler accessory that is mostly for looks.
What decides the price
Quotes are by hand, from ৳99. Small mounts use very little plastic and sit at the low end; bumpers and large covers cost more. Mounts break in crashes, so ordering two or three at once saves a second order later.
Send the link or file at krezit.cc/request and mention your frame or car model. Printing takes 2–3 days after you confirm, then courier delivery anywhere in Bangladesh.
Questions
- Can I get FPV drone parts 3D printed in Dhaka?
- Yes, Krezit prints drone accessories such as GoPro mounts, antenna holders and covers in PLA in Dhaka. Send a MakerWorld, Printables or Thingiverse link at krezit.cc/request and we reply with a price, usually the same day.
- Can PLA be used for a drone frame or motor mount?
- We advise against it. Motors can heat a mount past the 55–60°C where PLA softens, and PLA frame arms snap in crashes that carbon fibre would survive.
- Do you print in TPU or PETG?
- Not right now; everything is printed in PLA, in black or white. If a design was made for TPU, we will tell you honestly whether it still works in PLA before you pay anything.
- Will a PLA GoPro mount survive a crash?
- It holds a camera well in normal flying, but a hard crash can crack it, which sometimes spares the camera. It makes sense to treat mounts as consumables and order a spare or two.
