3D printed replacement parts in Dhaka
Updated
A small plastic part breaks and the whole thing stops working: a drawer knob, a blind clip, the battery cover on a remote. We print replacements in PLA for people in Dhaka whose part is discontinued, out of stock or simply not sold here.
Parts we can usually replace
- Cabinet, drawer and wardrobe knobs
- Clips for curtain rails, blinds and cable runs
- Battery covers for remotes, toys and kitchen scales
- End caps for furniture legs, tubes and rails
- Wall hooks and small brackets for light loads
- Dials for fans, radios and washing machines, as long as they never get hot
Check for a ready-made model first
Many common parts already exist as free models. Search MakerWorld, Printables or Thingiverse with the brand and model number of the thing that broke, such as the remote or the blind system. If you find a match, paste the link on the request form and the job is simple.
No model? Send photos and measurements
If nothing fits, describe the part in the request and give us what we need to judge it:
- Photos of the broken part from the front, side and underneath, with a ruler or measuring tape beside it
- Measurements in millimetres: length, width and height, hole diameters and the distance between holes
- Readings from calipers if you have them; a ruler is enough for simple shapes
- A photo of where the part fits, so we can see how it clips or screws in
We will tell you honestly whether we can model it from that. Knobs, caps and flat clips usually work. Parts with fine threads, springs or complex curves often do not, and we would rather say so than print a guess.
Where PLA is the wrong material
PLA starts to soften around 55–60°C. That rules out anything on or near a stove, iron, kettle, rice cooker, oven or heater, and knobs on hot appliances in general. It is also not for parts that carry weight where failure matters, such as a bracket under a heavy shelf, a car part, or anything that could hurt someone if it snapped. Clips and hooks for light everyday loads are fine.
What decides the price
Most replacement parts are small, so the plastic costs little. What matters is whether a model exists. A link to an existing file is quick to quote. A part we have to model from your photos takes more work, and we may suggest printing two versions at slightly different sizes so one fits first time. Orders start at ৳99.
Send the link, or the photos and measurements, through the request form at krezit.cc/request. We reply with a price on WhatsApp or email, usually the same day.
Questions
- Can you copy a broken plastic part?
- Often, yes. Send Krezit clear photos with a ruler in shot and the main measurements in millimetres, and we will tell you honestly whether we can model it. Simple knobs, caps and clips are the most likely to work.
- Can I use a printed knob on my gas stove or iron?
- No. PLA softens at around 55–60°C, so it should not be used on stoves, irons, kettles or any other hot appliance. We will say no to parts meant for those uses.
- Is a printed part as strong as the original?
- For light-duty parts such as clips, caps and battery covers it is usually close enough. PLA is not suitable for load-bearing or safety-critical parts, so do not trust a printed bracket with anything heavy.
- How long does a replacement part take to arrive?
- Printing takes 2–3 days after you confirm the quote, and the part then goes by courier anywhere in Bangladesh. You can follow it at krezit.cc/track with your REQ reference.
